All original content for this project is distributed open source under Creative Commons 2.5 Attribution / Share-Alike.

• EagleCAD files for mainboard, 2 batteryboards (li-ion/AAA), antenna overlay
• Tiled gerbers, drill and dimension print (all four PCBs)
  Tiled gerbers, drill and dimension print for Antenna/LiIon/Main (three PCBs)
• Top and bottom placements in PDF
• Schematic in PDF
• Firmware (pretty much the same as RC1)

• EagleCAD files for mainboard, 2 batteryboards (li-ion/AAA), antenna overlay
• Tiled gerbers, drill and dimension print (all four PCBs)
• Top and bottom placements in PDF
• Schematic in PDF
• Firmware

Note that there are 3 minor errors in RC1: RX/TX swapped, missing 0.1uF capacitors for PLL output and the DC jack tip and ring-switch is swapped.